10-D-18-HZ Approved as Modified

Install rooftop 3'-6" -high guardrail to be set back from building's front edge so that no more than 21 inches will be visible when standing against the opposite façade of Market Square. The top and bottom of the guardrail is to be a 2x2 steel angle and welded to 2x2 posts. The design of the balustrade is to match that of 29 Market Square with horizontal steel cables.

11-G-18-HZ Approved as Modified

Reconstruction of front porch based on documentary photographs and remaining physical evidence as per drawings dated 10-12-18 and 10-11-18. Columns to be either round or square on brick piers.

11-H-18-HZ Approved with Conditions

Construction of a detached hipped-roof garage sheathed in wood board and batten siding. The setback is to be 12 feet from the alleyand 5 feet from the side lot line. The side setback would be 5 feet. The pedestrian door is to be 4-or 5-paneldoor and the material is to be painted fiberglass. 1/1 single-hung wood or fiberglass windows to be similar to those of the house. Asphalt roof shingles will be similar to those on the house. The foundation is to be of smooth-finish stucco.

11-I-18-HZ Approved with Conditions

LEVEL II
Restore architectural features on front right of the house: window bay, cornices, and fascia. Foundation material is cinderblock and will be covered with stucco for the main house and additions. The front right section of house will have brick façade on foundation.Reconstruct the two- level porch on the front of the house with 6"- turned posts, tongue-and-groove flooring, and stained bead-board ceiling of upper level. There will be 3 turned posts on front (one on each side and one in middle) and a fourth half-post on the west side for each level. Sawn brackets to be added at the top of each turned post with type to match those on the second level of the house. Additions to be sheathed in smooth-finish fiber cement board. The roof over the porch will also be reconstructed with a roof pitch to be~ 5:12. The balustrade is proposed to be 36-inches high with turned balusters. Front porch balustrade design to be approved by MPC staff before construction.

The west rear of the house will have an addition of approximately 6'x11' with 6" offsets on west side and 1' offsets from the existing structure at the rear. The addition is proposed to be 2 levels.

The east rear of the house will have an addition of approximately 4'x11' with 6" offsets on east side and 1' offsets from the existing structure at the rear. The addition will be two stories. Roof over the two additions to be a shed roof with a pitch of 4:12.

Corner boards and fascia to be added to the addition corners to match the rest of the house. Additions to have 1/1 double-hung vinyl windows with dimensions of 36" x 72".

The openings in the rear wall are to be configured so that the rear door will be centered and there will be an upper and lower double-hung 1/1 window on each level-- aligned with each other. Rear door to be new 1/2 -light fiberglass or solid four or five-panel door. 2x2-inch square wood balustrade a back door if needed.
LEVEL I:
Remove vinyl siding, replace with in smooth-finish fiber cement board siding with reveal to match existing on the front of the house.
Replace gutters.
Replace windows with new vinyl 1/1 double-hung windows, same windows to be used in the addition. Window sizes are approximately 36"x72".
New roof with asphalt shingles.
Repair/replace fascia/soffit as needed with in smooth-finish fiber cement board.
Front door to be replaced with period-appropriate door approved by staff.