1-B-14-HZ Approved with conditions

1) Remove non-original concrete pillars and replace with 12" square wooden porch supports with wood trim pieces to match that on:
a) the columns of 1101 Luttrell (See submitted photo.); or
b.) the columns of submitted 1920s to 1930s documentary photo showing Ionic volutes at top.

2) Install a single french door panel in center bay of upper level that would be fixed and nonoperable if a 24-inch- high sqaure balustrade is erected, or a 1/1 sim div. light window if no balustrade is erected.

3) Install wood handrail at front steps and wood balustrade of 2x2 square with molded handrail to meet code-required height at 36".

4) Eliminate vertical strips in fascia board on front porch with by replacing board with smooth wood panel and molded trim along top and bottom.

5) Construct new front steps from brick to match that revealed on foundation or repair and existing concrete steps.

2-E-14-HZ Approved

The proposed addition will constructed within the original footprint, and the elevation design will be based on the submitted photo from August of 2007 that indicates wood lap siding and a multi-light window. The exit door will closely replicate the other exterior wood paneled doors. A total of five 6/6 wood double-hung windows to match the existing will be installed on the east elevation of the addition.

Additionally, the steps to the basement level on the rear of the house are proposed to be enclosed with a front -gabled lap-sided structure as indicated by the submitted photograph. Roof shingles will match those on the house.

The drive ailse is to be eliminated from the front of the house. This area will be grassed and landscaped instead as per site plan submitted 1-30-2014. The greatest drive-aisle width is to be 22 feet.